Expo 2023 – Episode 36 – Advanced Tech Feature: Roughness vs Waviness
This episode is an advanced class in roughness vs waviness, and why understanding waviness in critical to ensuring uniform clamping force on today's MLS gaskets
Expo 2023 – Episode 35 – Product Spotlight: Point One Manufacturing
Joe Castello, Ben Strader, and Billy Godbold sit down with Kevin Feeny of P1 to talk about the company’s new line of high performance studs and fasteners
Expo 2023 – Episode 34 – Tech 101 Feature: Torque vs Stretch
We head out with to Jasper Engines & Transmissions in Jasper, Indiana for a master class on torque vs stretch and how to get the right bolt clamp force.
Expo 2023 – Episode 33 – Engine Builder Interview: Greg & Aaron Stanfield
In another joint episode with the Hidden Horsepower Podcast, Joe and Lake sit down for an interview with NHRA father and son legends, Greg and Aaron Stanfield
Expo 2023 – Episode 32 – Tech 101: Bore Geometry & Clamp Load
Rottler Manfacturing’s Ed Kiebler shows us why clamp load simulating what the cylinder experiences in the engine is key to honing the proper bore geometry
Expo 2023 – Episode 31 – Combustion Analysis Roundtable
Lake and Joe sit down with George Bryce, Mark Cronquist, Ben Strader, & Billy Godbold to talk about why in-cylinder pressure "disrobes everyone"
Expo 2023 – Episode 30: In-Cylinder Combustion Analysis
Lake and Ben Strader head out to EFI University to show how combustion analysis for each cylinder allowed them to gain 39ft-lb of torque in their LS engine
Expo 2023 – Episode 29 – Show Open & Hands-on Training Opportunities
Lake and Joe open Day 2 of Expo 2023 with a tease of the day's events and an announcement of new hands-on training programs available to Expo viewers
Expo 2023 – Episode 28 – Roundtable: The Future of the Internal Combustion Engine
Lake and Joe host an expert roundtable on the future of the internal combustion engine and why an all-electric future is by no means a foregone conclusion
Expo 2023 – Episode 27 – Tech 101: Balance Then Dampen
Lake and Ben Strader go to the shop floor to talk with Randy Neal of CWT Technologies, and discuss the balancing versus dampening, and why you need both